WithLarry HaunandScott Grice
One way to makeframing简单是建立一个墙在甲板上平。的某个时候s you have to pull it out from its normal position, where it’s going to be permanently, to the flat deck. Pull the two plates apart, knock the nails over, and spread the walls apart to the distance of the studs.
Related Vidoes
Simple Steps for Window- and Door-Framing Layout
Tips for Laying Out Studs on Wall Plates
6 Tips for Spreading Wall Plates on a Subfloor
The Top 10 Tips for Wall-Framing Layout on a New Subfloor
Further Resources
1.FrameRough Openings First
找到的头,洛杉矶y it into position. If there is no top cripple, the header is nailed right up against the top plate. Using a nail gun makes the task even easier. Nail the studs into the king stud, which falls right against the header, and nail it into the end of the header. Do the same on the other end.
2. Ways to Frame Corners
Using a couple of the block scraps that are lying on the deck, nail the corner stud in, and pin-nail the blocks in.
Another way to make a corner on a 2×6 wall is to tie it in using a 2×6 on the flat, nailed in an L-shape with the end 2×4 of the wall. It allows 1-1/2 in. of the 2×6 to stick out on the other side so that drywall can tie into the corner. Nail it together in the L, making sure it’s flush on the outside, and lay in your wall. This method saves wood; you don’t have to use scraps.
3. Nail the Trimmers
The trimmers are cut 4 in. to 5-1/2 in. short of your wall stud. Some people nail them in hard, but there’s another way to do it. Put one nail in at the center. Nail on the double top plate. It’s important to nail the top plate right over the studs, which make a clear passage for an electrician or plumber.